GSI 10K 2 Post Automotive Lift - 10,000 LB Capacity Commercial Car & Truck Hoist for Auto Repair Shops, Garages, and Vehicle Maintenance

Commercial 10,000 LB Automotive Lift 2 Post Vehicle Lift Car Auto Truck Hoist - GSI 10k

The 10,000 LB Automotive Lift 2 Post Vehicle Lift Car Auto Truck Hoist 220V - Model 10k offer best-in-class features with unmatched fit, finish, and quality. These commercial grade lifts have been rigorously tested to withstand day in and day out operation making them the perfect solution for any high-volume service shop or even just the “Weekend Wrench” who’s looking to get their ride ready for the next event. Easy Wire Up To Single Phase Electrical Panel

Features & Specifications For Auto Lift:

• Features 220V 60HZ 1PH 3HP MOTOR
• Free adjustable truck pads adapters included
• Double Point Safety Lock Release
• Automatic arm lock restraints
• Relief valve built in power pump to prevent overloading
• Door guards protection rubber
• Heavy duty 5/16" diameter cable and 4.56" pulley reduce high stress on synchronization process and increase cable life
• Stiffened base plate 5/8" thickness
• Ultra high molecular self lubricating nylon slider ensures carriage smooth moving up and down
• Anchor bolts/mounting hardware included
• Lifting operation by pressing "UP" button on motor
• Manual lowering operation by pressing lever
• Relief valve built in power pump to prevent overloading
• 1 sets truck adapters included
• Lifting Capacity: 10,000 lbs
• The overall Height 110-1/4"
• The overall Width 134 21/32"
• Column Width 10.62"
• Base Width 18.89"
• Column Thickness of Steel 3/16"
• Carriage Thickness of Steel 15/64"
• Arms Thickness of Steel 15/64"
• Front Arm 30.7" to 48"
• Rear Arm 30.7" to 48"
• Min pad height: 3-7/8"
• Lift height max: 78-7/8"
• Drive-thru width clearance: 99 19/32"
• Time to full rise: 20-60 sec
• Shipping Weight: 1350 lbs.

Before installing your auto lift, check the following:
Lift Location: Always use architect’s plans when available. Check layout dimension against floor plan requirements making sure adequate space is available. Your lift
requires a 220v, 30amp, single phase, grounded electrical source. There should be room enough to operate the lift in a safe manner and without restrictions.
Overhead Area: The area where the lift will be located should be free of overhead obstructions such as heaters, building supports, electrical lines, doors, lights, etc.
Floor Area: Visually inspect the site where the lift is to be installed and check for cracked or defective concrete.
A level floor is suggested for proper installation and level lifting. Small differences in floor slopes may be compensated for by proper shimming. If a floor is of questionable slope, consider a survey of the site and/or the possibility of pouring a new level concrete slab.
New concrete must be adequately cured for at least 30 days.
DO NOT install auto lift on any asphalt surface or any surface other than concrete.
DO NOT install auto lift on expansion seams or on cracked or defective concrete.
DO NOT install auto lift on a second/elevated floor without first consulting building architect.
DO NOT install auto lift outdoors unless special consideration has been made to protect the power unit from inclement weather conditions.
All models MUST be installed on 3,000 PSI reinforced concrete only. Additional concrete requirements will vary by lift.
8,500 lbs – 10,000 lbs lifts: 4? Minimum Thickness
Easy Single Phase Hook Up For Commercial Or Residential use